|CESM Research Tools: CLM4.5 in CESM1.2.0 User's Guide Documentation|
|Prev||Chapter 5. How to run Single-Point/Regional cases||Next|
PTS_MODE enables you to run the model using global datasets, but just picking a
single point from those datasets and operating on it. It can be a very quick way to do fast
simulations and get a quick turnaround.
To setup a
PTS_MODE simulation you use the "-pts_lat" and "-pts_lon"
arguments to create_newcase to give the latitude and longitude of the point you want to
simulate for (the code will pick the point on the global grid nearest to the point you
give. Here's an example to setup a simulation for the nearest point at 2-degree resolution
to Boulder Colorado.
> cd scripts > ./create_newcase -case testPTS_MODE -res f19_g16 -compset I1850CRUCLM45BGC -mach yellowstone_intel \ -pts_lat 40.0 -pts_lon -105 > cd testPTS_MODE # We make sure the model will start up cold rather than using initial conditions > ./xmlchange
PTS_MODEcurrently CAN NOT run with initial conditions.
Note: This works the same for CLM4.0 and CLM4.5.
Important: By default it sets up to run with
MPILIB=mpi-serial(in the env_build.xml file) turned on, which allows you to run the model interactively. On some machines this mode is NOT supported and you may need to change it to FALSE before you are able to build.
Note: You can change the point you are simulating for at run-time by changing the values of
PTS_LONin the env_run.xml file.
Note: Note, that when running with
PTS_MODEthe number of processors is automatically set to one. When running a single grid point you can only use a single processor. You might also want to set the env_build.xml variable:
MPILIB=mpi-serialto TRUE so that you can also run interactively without having to use MPI to start up your job.