Adding Resolution Names

If you are adding files for new resolutions which aren't covered in the namelist_definition file -- you'll need to add them in. The list of valid resolutions is in the id="res" entry in the models/lnd/clm/bld/namelist_files/namelist_definition_clm4_5.xml file. You need to choose a name for your new resolution and simply add it to the comma delimited list of valid_values for the id="res" entry. The convention for global Gaussian grids is number_of_latitudes x number_of_longitudes. The convention for global finite volume grids is latitude_grid_size x longitude_grid_size where latitude and longitude is measured in degrees. The convention for unstructured HOMME grids is ne<size>np4, where <size> corresponds to the resolution. The higher <size> is the higher the resolution. So for example, ne60np4 is roughly half-degree while ne240np4 is roughly a eighth degree. For regional or single-point datasets the names have a grid size number_of_latitudes x number_of_longitudes followed by an underscore and then a descriptive name such as a City name followed by an abbreviation for the Country in caps. The only hard requirement is that names be unique for different grid files. Here's what the entry for resolutions looks like in the file:

<entry id="res" type="char*30" category="default_settings"
Horizontal resolutions
Note: 0.1x0.1, 0.5x0.5, 5x5min, 10x10min, 3x3min, 1km-merge-10min, and 0.33x0.33 are only used for CLM tools
As you can see you just add your new resolution names to the end of the valid_values list.

When using PTCLM and adding supported single-point resolutions, you'll also want to add these resolutions to the models/lnd/clm/bld/config_files/config_definition.xml under the sitespf_pt name. The entry in that file looks like:

<entry id="sitespf_pt" 
value="none" category="physics">
Flag to turn on site specific special configuration flags for supported single 
point resolutions. See the specific config_defaults_*.xml file for the special 
settings that are set for a particular site.
PTCLM assumes that any supported single-point resolutions are valid settings for sitespf_pt.